CABINET PLANNER DEFAULT LOCATION WINDOWS

When calculating Master lists- These two check boxes tell the program what to do with the master lists when calculating them.

Tenon length for face frames- The size entered in this box will be doubled and add to all appropriate face frame sizes Entering 'X' will give you decimals only. If they are an exact fraction, then that fraction will be given down to 1/32. Entering 'N' will have the program give exact sizes. Round to nearest 1/16- Entering 'Y' will tell the program to trim sizes to the nearest 1/16. Tenon length for doors-The size entered in this box is doubled and added to all door and raised panel rails and middle rails or stiles where appropriate Shelf edge thickness- amount to deduct from overall shelf depthДeduct for shelf length- lets you set how much is deducted from adjustable shelf's lengthДeduct for shelf depth- lets you set how much is deducted from adjustable shelf's depthДoor stile and rail cutter depth- This size is used to figure how much to add to the rails of doors.

This works only when planning a lob from left to right.Д¬lick & Drag- Checking this box will keep the click & drag feature enabled. Location assist- Checking this box will fill in the location box with the location + the width of the last saved cabinet in a job. Rabbet depth for sides-This is how much the front and back is rabbeted into the sides of the drawer box.Дado depth for bottoms-This is how much the bottoms are dadoed into the sides, fronts and backs of the drawer boxes. This setting will let you adjust the height of base cabinet partitions to allow for stretchers to run above them without having to cut a notch for them.Дeduct for width-This is how much to deduct from the drawer opening for figuring the overall width of the drawer box.Дeduct for height-This is how much to deduct from the drawer opening for figuring the height of the drawer box.Дeduct for depth-This is how much is deducted from the cabinet depth for figuring drawer box depth. The size entered in this box on the base cabinet standards window will be applied to all base cabinets, vanities, and tall cabinets.

CABINET PLANNER DEFAULT LOCATION WINDOWS

The size entered in this box on the upper cabinet standards windows will be applied to all upper cabinets.

The size you enter in this box is the amount that the bottom rail sticks up above the bottom of the cabinet. If you set scribe to a side of the cabinet, the program will only shorten the box by that amount.Entering 2 will run the bottom through on sides with scribe applied to them and shorten that sides length by the amount of the bottom rail minus the bottom lip size. Entering 1 in this box will plan upper cabinets with the top and bottom of equal lengths.

Cabinet planner default location